2. Remove the tape (1) that secures the WLAN and WWAN cables to the system board. (2).
3. Turn the computer right side up, facing you. Feed the WLAN and WWAN cables through the
hole next to the keyboard screw (1), and then lift the cable free of the routing areas (2).
Disconnect the webcam cable (3).
4. Position the computer with the rear towards you.
CAUTION: Support the display assembly when removing the display screws in the following
steps. Failure to support the display assembly can result in damage to the assembly and other
components.
Component replacement procedures 89
To Next Page
Loading...
