5. Disconnect the display panel cable (1), and then remove the cable (2).
NOTE: Make sure all cables are freed from the clips in the routing channel.
6. Turn the unit around, and then remove the Torx M2.5x7.0 screws (1) that secure the display
hinges to the base enclosure. Next, remove the Torx M2.5x3.0 screws (2) that secure the hinge
cover to the base enclosure. Remove the four 8 millimeter Torx screws (3) that secure the hinge
cover to the base enclosure.
90 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
