SSD drive
Description Spare part number
Solid-state drive
512-GB, TLC 848878-001
256-GB, SED, OPAL2, MLC 844406-001
256-GB, PCIe, MLC 844405-001
256-GB, TLC 844408-001
240-GB, TLC 844407-001
180-GB, MLC 844403-001
180-GB, SED, OPAL2, MLC 844404-001
128-GB, TLC 844402-001
Before removing the hard drive, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 28).
5. Disconnect the battery (see Battery on page 29).
Remove the SSD:
1. Remove the Phillips PM2.0×3.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE: mSATA drives are designed with notches to prevent incorrect insertion.
Reverse this procedure to reassemble and install the SSD drive.
32 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
