Smart Card reader
Description Spare part number
Smart Card reader (includes cable)
NOTE: The Smart Card reader insert is included in the Plastics/Rubber Kit, spare part number
844400-001.
844412-001
Before removing the Smart Card reader, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see Bottom cover on page 28)
5. Remove the battery (see Battery on page 29).
6. Remove the system board (see System board on page 48).
Remove the Smart Card reader:
1. Remove the three Phillips PM2.0×3.0 screws (1) that secure the reader to the computer.
2. Remove the Smart Card reader from the computer (2).
Reverse the removal procedures to install the Smart Card reader.
54 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
To Next Page
Loading...
