HP EliteBook Folio 1040 G3 - Display Assembly

Display assembly
Description Spare part number
Touch screen displays:
●
Without WWAN and with webcam 844386-001
●
With WWAN and with webcam 849783-001
Non-touch screen displays:
●
FHD, SVA 846579-001
●
QHD, UWVA 846580-001
●
FHD, SVA, with WWAN 849777-001
●
FHD, SVA, with webcam 849778-001
●
FHD, SVA, with WWAN and webcam 849779-001
●
QHD, UWVA, with WWAN 849780-001
●
QHD, UWVA, with webcam 849781-001
●
QHD, UWVA, with WWAN and webcam 849782-001
NOTE: The display is spared only as a full hinge-up. Individual subcomponents are not spared.
Before removing the display assembly, follow these steps:
1. Turn o the computer. If you are unsure whether the computer is o or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Bottom cover (see Bottom cover on page 28).
5. Disconnect the battery (see Battery on page 29).
Remove the display assembly:
1. Close the computer and place it upside down.
2. Remove the WWAN antennas from the clips in the left fan and the WWAN module (1).
3. Remove the WLAN antennas from the clips in the left fan and the WLAN module (2).
4. Remove the display cable from the clips in the chassis, and then disconnect the cable from the system
board (3).
Component replacement procedures 39