Table 2-14 Service label components and their descriptions
Component
(1) HP product name
(2) Product ID
(3) Serial number
(4) Warranty period
Inserting a nano SIM card (select products only)
To insert a SIM card, follow these steps.
IMPORTANT: Inserting a SIM card of the wrong size or inserting the SIM tray in the wrong direction could
damage the SIM card, damage internal components, or cause the SIM card to become stuck in the slot. Do not
use SIM card adapters. To prevent damage to the SIM tray and internal connectors of the computer, use minimal
force when you insert or remove a SIM tray. Be sure to insert the SIM tray in the same orientation as it was when
you removed it.
Before purchasing a SIM card, follow these instructions to determine the correct SIM card size for your computer:
1. Go to http://www.hp.com/support, and then search for your computer by product name or number.
2. Select Product Information.
3. Refer to the listed options to determine which card to purchase.
To insert a SIM card, follow these steps:
1. Position the computer display-side up on a at surface.
2. Press in gently on the SIM tray (1) to release the tray.
3. Holding the end of the tray, pull the tray (2) straight out from the computer, and then insert the SIM card
(3).
NOTE: Be sure that the SIM card and SIM tray are properly aligned.
4. Replace the tray in the computer with the same orientation as it was when you removed it. Press in gently
on the tray (4) until it is rmly seated.
NOTE: The SIM tray in your computer might look slightly dierent from the illustration in this section.
18 Chapter 2 Components ENWW
To Next Page
Loading...
