3. Remove the two Phillips M2.0 × 5.0 screws (3) that secure the connector board to the computer.
4. Remove the connector board (4) and cable.
Reverse this procedure to install the connector board.
Display assembly
To remove the display assembly, use these procedures and illustrations.
Table
5-6 Connector board description and part number
Description Spare part number
Touchscreen display assembly:
14.0 in, LCD, UHD (3840×1980), brightview, LED, UWVA, HDR 550; typical brightness: 400 nits M16039-001
14.0 in, LCD, FHD (1980×1080), brightview, LED, UWVA, SVR; typical brightness: 1000 nits M16041-001
14.0 in, LCD, FHD (1980×1080), brightview, LED, UWVA, LP; typical brightness: 400 nits M16038-001
14.0 in, LCD, FHD (1980×1080), brightview, LED, UWVA, SVR; typical brightness: 1000 nits M16040-001
14.0 in, LCD, FHD (1980×1080), antiglare, LED, UWVA, LP; typical brightness: 400 nits M16037-001
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 44).
2. Remove the bottom cover (Bottom cover on page 44).
3. Disconnect the battery cable from the system board the battery (see Battery on page 45).
Remove the display assembly:
52 Chapter 5 Removal and replacement procedures for authorized service provider parts ENWW
To Next Page
Loading...
