9. Remove the left speaker (4) .
NOTE: When removing the left speaker, make note of the location of the rubber isolator (5). The absence
of or damage to this isolator can result in degraded left speaker performance.
Reverse this procedure to install the speakers.
Touchpad cable
To remove the touchpad cable, use this procedure and illustration.
NOTE: The touchpad cable is available in the Cable Kit, spare part number M20833-001.
Before removing the touchpad cable, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 44).
2. Remove the bottom cover (Bottom cover on page 44).
3. Remove the battery (see Battery on page 45).
Remove the touchpad cable:
1. Release the ZIF connector (1) to which the touchpad cable is connected, and then disconnect the cable
from the system board.
2. Release the ZIF connector (2) to which the touchpad cable is connected, and then disconnect the cable
from the touchpad.
56 Chapter 5 Removal and replacement procedures for authorized service provider parts ENWW
To Next Page
Loading...
