5. Remove the four Phillips M2.0 × 5.0 screws that secure the system board to the computer.
6. Lift the front edge of the system board (1) until it rests at an angle.
7. Remove the system board (2) by sliding it up and forward at an angle.
Reverse this procedure to install the system board.
Fan/heat sink assembly
To remove the fan/heat sink assembly, use these procedures and illustrations.
Table
5-12 Fan/heat sink assembly descriptions and part numbers
Description Spare part number
Fan/heat sink assembly (includes replacement thermal material) M16006-001
Before removing the fan/heat sink assembly, follow these steps:
64 Chapter 5 Removal and replacement procedures for authorized service provider parts ENWW
To Next Page
Loading...
