3. Remove the connector board cable (3).
Reverse this procedure to install the connector board cable.
Connector board
To remove the connector board, use this procedure and illustration.
Table
5-5 Connector board description and part number
Description Spare part number
Connector board (includes audio-out (headphone)/audio-in (microphone) combo jack, nano SIM card slot
(select products only), and USB SuperSpeed port)
NOTE: The connector board spare part kit does not include the connector board cable. The connector board
cable is available in the Cable Kit, spare part number M20835-001.
M16050-001
Before removing the connector board, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 44).
2. Remove the bottom cover (Bottom cover on page 44).
3. Disconnect the battery cable from the system board the battery (see Battery on page 45).
4. Remove the WWAN module (see WWAN module on page 48).
Remove the connector board:
1. Remove the nano SIM tray (1) from the mini media card reader slot.
The nano SIM tray is available using spare part number M16053-001.
2. Release the ZIF connector (2) to which the connector board cable is connected, and then disconnect the
cable from the system board.
ENWW Component replacement procedures 51
To Next Page
Loading...
