3. Remove the touchpad cable (3).
Reverse this procedure to install the touchpad cable.
Touchpad
To remove the touchpad, use this procedure and illustration.
Table
5-8 Touchpad description and part number
Description Spare part number
For use only on computer models equipped with NFC capability M16010-001
For use only on computer models not equipped with NFC capability M16005-001
NOTE: The touchpad spare part kit does not include the touchpad bracket or touchpad cable. The touchpad bracket is not available as a
spare part. The touchpad cable is available in the Cable Kit, spare part number M20835-001.
Touchpad bracket: The touchpad bracket is not available as a spare part.
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (Preparation for disassembly on page 44).
2. Remove the bottom cover (Bottom cover on page 44).
3. Remove the battery (see Battery on page 45).
Remove the touchpad:
1. Detach the touchpad cable (1) from the top cover/keyboard. (The touchpad cable is attached to the top
cover/keyboard with double-sided adhesive.)
2. Release the ZIF connector (2) to which the touchpad cable is connected, and then disconnect the cable
from the system board.
Steps 3 and 4 apply only to computer models equipped with an NFC module and cable.
ENWW Component replacement procedures 57
To Next Page
Loading...
