9. Connect the power cable (1) and data cable (2) to the rear of the optical drive.
10. Connect the opposite end of the data cable to one of the light blue SATA connectors on the system
board.
NOTE: Refer to System board connections on page 12 for an illustration of the system board drive
connectors.
11. Replace the front bezel if it was removed.
12. Replace the computer access panel.
13. Reconnect the power cord and any external devices, and then turn on the computer.
14. Lock any security devices that were disengaged when the access panel was removed.
Removing and installing drives 31
To Next Page
Loading...
