Removing a bezel blank
On some models, there is a bezel blank covering the slim optical drive bay that needs to be removed
before installing a slim optical drive. To remove a bezel blank:
1. Remove the access panel and front bezel.
2. To remove the bezel blank, press inward on the six retaining tabs (1) and pull the blank off the
front bezel (2).
NOTE: After removing the slim optical drive bezel blank and installing a slim optical drive, you
can install an optional bezel trim piece (available from HP) that surrounds the front of the slim
optical drive.
ENWW Removing a bezel blank 103
To Next Page
Loading...
