HP Engage One 2D User Manual

Scanning in hands-free mode
When the scanner is seated in the stand the scanner’s built-in sensor places the scanner in hands-free mode.
When the scanner is removed from the stand it operates in its normal hand-held mode.
1. Make sure that all cable connections are secure.
2. Insert the scanner in the stand by placing the scanner onto the stand.
3. To scan a bar code, place the bar code up to the scanner and make sure that the scan line crosses every
bar and space of the symbol.
4. Upon successful decode, the scanner beeps and the LED turns green.
Standard product defaults
The following bar code resets all standard product default settings.
Standard Product Defaults
Keyboard country
Scan the Program Keyboard Country bar code below, then scan the numeric bar code(s) from the
Programming chart on page 5, and then scan the Save bar code to program the keyboard for your country.
As a general rule, the following characters are not supported by the scanner for countries other than the
United States:
@ | $ # { } [ ] = / ‘ \ < > ~.
Program Keyboard Country
Country Code Scan Country Code Scan
Belgium 1 Italy 5
Brazil 16 Japan 28
Czechoslovakia 15 Latin America 14
Denmark 8 Russia 26
Finland 2 Slovakia 22
France 3 Spain 10
Germany/Austria 4 Switzerland 6
Great Britain 7 USA (Default) 0
Norway 9
2 Chapter 1 Using the scanner

HP Engage One 2D Specifications

General

Brand	HP
Model	Engage One 2D
Category	Barcode Reader
Language	English