Remove the fan/heat sink assembly:
1. Turn the system board upside down, with the front toward you.
2. Disconnect the fan cable (1) from the system board.
3. Remove the Phillips PM2.0×3.5 screw (2) that secures the fan/heat sink assembly to the
system board.
4. Following the 1, 2, 3, 4 sequence stamped into the fan/heat sink assembly, loosen the four
captive Phillips screws (3) that secure the fan/heat sink assembly to the system board.
Component replacement procedures 57
This manual downloaded from http://www.manualowl.com
To Next Page
Loading...
