HP EVA P6000 Software Guide

Figure 26 I/O tab of Disk Enclosure Properties window
NOTE: The Firmware revision fields are different for EVAx400 and P6000 disk
enclosures.
If the fields Assembly serial number, Hardware revision, and Hardware type on the I/O
tab of the Disk Enclosure Properties window are blank, you can optionally reset the I/O
modules to clear the blank fields after the I/O module firmware upgrade has completed
successfully. Note that blank fields do not affect the array's ability to process host I/O.
See “Resetting the I/O module” (page 55) for more information.
e. Check the operational states that you recorded and proceed as follows:
• Good: No action
• Loading firmware: The I/O module firmware load is blocked. Corrective action is
required somewhere on the array (but not on this I/O module). Continue with Step
18
• Any state other than Good or Loading firmware: Corrective action is required on
this I/O module. Continue with Step 18.
18. Check the event log for the code-load-blocked code (066df308, critical event). If you do not
see this event, contact your HP-authorized service representative for assistance. If you see this
event, continue with Step 19.
54 Upgrading the Enterprise Virtual Array

HP EVA P6000 Specifications

General

Model	HP EVA P6000
Number of Storage Controllers	2
Management Software	HP Command View EVA
Drive Types	SAS, SSD
RAID Levels	RAID 0, 1, 5, 6
Connectivity	8 Gb Fibre Channel, 10 Gb iSCSI, 1 Gb iSCSI
Form Factor	Rack-mounted
Storage Controller Type	Dual controllers