HP Ew2400 - JetDirect Print Server User Manual

ENWW Using the Embedded Web Server 125
Scan Idle Timeout Specifies the number of seconds that an idle connection for
scanning is allowed to remain open. The maximum is 3600, and
the default is 300. If set to 0, the timeout is disabled and the
connection will remain open until closed by the network system
that is accessing the device.
Locally
Administered
Address
Specifies a locally administered address (LAA) that replaces the
factory-assigned LAN Hardware (MAC) address. If LAA is used,
a user-specified string of exactly 12 hexadecimal digits must be
entered.
For Ethernet print servers, the LAA address must start with
hexadecimal X2, X6, XA, or XE, where X is any hexadecimal digit
0 through F.
The default address is the factory assigned address.
Syslog Facility Specify the encoded source facility of a message (for example,
to identify the source of selected messages during
troubleshooting). By default, the HP Jetdirect print server uses
LPR as the source facility code, but local user values of local0
through local7 can be used to isolate individual or groups of print
servers.
On fatal error (Supported external print servers only) Specify the print server’s
action when it detects a fatal error during operation with the
attached device:
● Halt (default): The print server’s networking operation is
suspended. User intervention will be required.
● Reboot: The print server will restart, similar to when the printer
is powered off/on.
Error page type (Supported external print servers only) Specify the type of
diagnostic page that will automatically print on a fatal error.
● Basic (default): A Default Diagnostic Page will print. It is a
single page containing an error summary in user-readable
form.
● Full: Up to five pages of full diagnostic information will be
printed.; These pages will contain detailed status of the print
server at the time the error was detected. HP support
personnel may be required to interpret the pages.
● None: A diagnostic page will not be printed.
Dynamic Raw
Port Setting
Allows additional ports to be specified for printing to TCP port
9100. Valid ports are 3000 to 9000, which are
application-dependent.
Table 4.8 Miscellaneous Settings (3 of 5)
Item Description

HP Ew2400 - JetDirect Print Server Specifications

General

Brand	HP
Model	Ew2400 - JetDirect Print Server
Category	Print Server
Language	English