ENWW HP Jetdirect Configuration Page 206
PORT SELECT: (Ethernet only) Specifies the port on the HP Jetdirect print
server that has been detected for use:
NONE: The print server is not connected to the network.
RJ-45: The RJ-45 network port is connected.
LAA The Locally Administered Address (LAA) identifies the
user-specified LAN hardware address of a print server,
which may be required by some network adiministrators.
The default address is the print server’s factory-default LAN
hardware address.
PORT CONFIG: Identifies the link configuration of the RJ-45 port on the
HP Jetdirect 10/100Base-TX print server:
10BASE-T HALF: 10 Mbps, half-duplex
10BASE-T FULL: 10 Mbps, full-duplex
100TX HALF: 100Mbps, half-duplex
100TX-FULL: 100Mbps, full-duplex
UNKNOWN: The print server is in an initialization state.
DISCONNECTED: A network connection has not been
detected. Check network cables.
AUTONEGOTIATION Identifies whether IEEE 802.3u Autonegotiation on the
HP Jetdirect 10/100TX port is enabled (ON) or disabled
(OFF).
ON (default): The HP Jetdirect print server will attempt to
automatically configure itself onto the network at the proper
speed (10 or 100 Mbps) and mode (half or full duplex).
Autonegotiation is enabled after a cold reset.
OFF: You must manually configure the speed and mode
using the EIO menu from the printer’s control panel. If
Autonegotiation is off, the settings must match those of
the network for proper operation.
MANUFACTURING ID: The manufacturing identification code for use by HP online
support personnel.
DATE
MANUFACTURED:
Identifies the date of manufacture of the HP Jetdirect print
server.
Table 9.1 HP Jetdirect Configuration (2 of 2)
Message Description
To Next Page
Loading...
Need help?
General
