HP Ew2400 - JetDirect Print Server User Manual

ENWW HP Jetdirect Configuration Page 226
09 SCANNING FOR
SSID
(802.11 Wireless) The print server is scanning on all
channels for devices on the specified SSID (network name).
Check your specified SSID, or check status of the Access
Point (Infrastructure mode) or other wireless devices.
The print server will continue to scan for the specified SSID.
0A LAN ERROR -
NO SQE
(Wired Ethernet) Check the network connections. If the
connections are intact, run the power-on self-test: turn the
printer off, then on again. If the error persists, replace the
HP Jetdirect print server.
0C LAN ERROR -
RECEIVER OFF
There may be a problem with your network cabling or the
HP Jetdirect print server. Check the cabling and connectors
on your Ethernet network. If you cannot find a problem with
your network cabling, run the power-on self-test: turn the
printer off, then on again. If the error persists after the printer
is turned on again, there is a problem with the HP Jetdirect
print server.
0D LAN ERROR -
TRANSMITTER OFF
There may be a problem with your network cabling or the
HP Jetdirect print server. Check the cabling and connectors
on your Ethernet network. If you cannot find a problem with
your network cabling, run the power-on self-test: turn the
printer off, then on again. If the error persists, there is a
problem with the HP Jetdirect print server.
0E LAN ERROR -
LOSS OF CARRIER
Check the network connections. If the connections are
intact, run the power-on self-test: turn the printer off, then
on again. If the error persists, replace the HP Jetdirect
print server.
10 LAN ERROR -
UNDERFLOW
(Wired Ethernet) There may be a problem with your network
cabling or the HP Jetdirect print server. Check the cabling
and connectors on your network. If you cannot find a
problem with your network cabling, run the power-on
self-test: turn the printer off, then on again. If the error
persists, there is a problem with the HP Jetdirect print
server.
11 LAN ERROR -
RETRY FAULTS
(Wired Ethernet) There is a problem with your network
cabling or external network configuration. Verify operation
of the hub or switch port.
12 LAN ERROR -
NO LINKBEAT
With a 10/100 Base-TX port connected, this message is
displayed if Link Beat is not sensed. Check the network
cable, and verify that the concentrator/hub is providing Link
Beat.
13 NETWORK
RECONFIG - MUST
REBOOT
Reset or power off/on the HP Jetdirect print server to enable
new configuration values.
Table 9.11 Error Messages (2 of 11)
Error Code and
Message
Description

HP Ew2400 - JetDirect Print Server Specifications

General

Brand	HP
Model	Ew2400 - JetDirect Print Server
Category	Print Server
Language	English