ENWW TCP/IP Configuration 50
Table 3.3 TFTP Configuration File Parameters (1 of 12)
General
passwd:
(passwd-admin:)
A password (up to 16 alphanumeric characters) that allows administrators to
control changes of HP Jetdirect print server configuration parameters through
Telnet, HP Web Jetadmin, or embedded Web server. The password may be
cleared by a cold reset.
sys-location:
(host-location:, location:)
Identifies the physical location of the printer (SNMP sysLocation object). Only
printable ASCII characters are allowed. The maximum length is 64 characters. The
default location is undefined. (Example: 1st floor, south wall)
sys-contact:
(host-contact:, contact:)
ASCII character string (up to 64 characters) that identifies the person who
administers or services the printer (SNMP sysContact object). This may include
how to contact this person. The default contact is undefined.
ssl-state:
Sets the print server’s security level for Web communications:
1 (default): Forced redirection to the HTTPS port. Only HTTPS (secure HTTP)
communications can be used.
2: Disable forced redirection to HTTPS. Both HTTP and HTTPS communications
can be used.
security-reset:
Reset security settings on the print server to factory default values. 0 (default) does
not reset, 1 resets the security settings.
tftp-parameter-attribute:
Specifies whether TFTP parameters can be manually overwritten on the print
server (for example, through Telnet) after it has been configured by TFTP.
tftp-ro (default): Do not allow TFTP parameters to be manually changed, and
always overwrite manual configurations.
tftp-rw: Allow TFTP parameters to be manually changed, and always overwrite
manual configurations.
manual-ro: Do not allow TFTP parameters to overwrite manually configured
parameters.
To Next Page
Loading...
Need help?
General
