ENWW TCP/IP Configuration 79
Telnet Commands and Parameters. Table 3.4 lists the
available Telnet commands and parameters.
Note If a parameter is supplied dynamically (for example,
from a BOOTP or DHCP server), its value cannot
be changed using Telnet without first setting
Manual configuration. To set Manual configuration,
see the ip-config command.
Whenever you are manually changing an IP
address, you should also reconfigure the subnet
mask and default gateway at the same time.
Table 3.4 Telnet Commands and Parameters (1 of 18)
User Control Commands
Command Description
? Displays the Help and Telnet commands.
/ Displays current values.
menu Displays the Menu Interface
for access to configuration
parameters.
advanced Enables the Advanced commands. Help (?) will include the
Advanced commands in the list.
general Disables the Advanced commands. Help (?) will not include
Advanced commands (default).
save Save the configuration values and exit the session.
exit Exit the session.
export Export the settings to a file for editing, and importing through
Telnet or TFTP (this command is only supported by systems,
such as UNIX, that support input/output redirection).
General
Command Description
passwd Set the administrator password (shared with the embedded
Web server and HP Web Jetadmin). For example,
“passwd jd1234 jd1234” sets the password to jd1234.
Note that “jd1234” is entered twice for confirmation.
Up to 16 alphanumeric characters may be used. When
initiating the next Telnet session, you will be prompted for a
user name and this password.
To clear the password, enter the command without
password and confirmation entries.
Passwords may be cleared by a cold reset.
To Next Page
Loading...
Need help?
General
