EasyManuals Logo

HP Ew2400 - JetDirect Print Server User Manual

HP Ew2400 - JetDirect Print Server
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #90 background imageLoading...
Page #90 background image
ENWW TCP/IP Configuration 90
phone-home-config Specifies privacy settings on the print server during
embedded Web server access. This command controls
whether statistical data on product use may be sent to HP.
For HP to collect data, Internet access is required.
2: Prompt the user to allow sending data on initial access to
the Networking tab of the embedded Web server. This is the
factory-default and cold-reset value. Once changed, this
value cannot be re-selected.
1: Allows the sending of data to HP without prompting the
user.
0: Disables sending data to HP without prompting the user.
TCP/IP Diagnostics
Command Description
Last Config IP (Read-only parameter) The IP address of the system from
which the HP Jetdirect print server’s IP address was
configured.
TCP Conns Refused (Read-only parameter) The number of client TCP
connections that are refused by the print server.
TCP Access Denied (Read-only parameter) The number of times that client
systems were denied access to the print server because
there was no allowable entry in the print server’s host access
list.
DHCP Lease Time (Read-only parameter) DHCP IP address lease duration
time (seconds).
DHCP Renew Time (Read-only parameter) DHCP T1 timeout, specifying the
DHCP lease renewal time (seconds).
DHCP Rebind Time (Read-only parameter) DHCP T2 timeout, specifying the
DHCP lease rebind time (seconds).
SNMP
Command Description
snmp-config Enables or disables SNMP operation on the print server.
0 disables, 1 (default) enables SNMP.
CAUTION: Disabling SNMP will disable all SNMP agents
(SNMP v1, v2, v3) as well as communications with
management applications, such as HP Web Jetadmin. In
addition, firmware upgrades through current HP
downloading utilities will be disabled.
get-cmnty-name Specifies a password that determines which SNMP
GetRequests the HP Jetdirect print server will respond to.
This is optional. If a user-specified get community name is
set, the print server will respond to either a user-specified
community name or the factory-default. The community
name must be ASCII characters. The maximum length is
255 characters.
Table 3.4 Telnet Commands and Parameters (12 of 18)

Table of Contents

Other manuals for HP Ew2400 - JetDirect Print Server

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Ew2400 - JetDirect Print Server and is the answer not in the manual?

HP Ew2400 - JetDirect Print Server Specifications

General IconGeneral
BrandHP
ModelEw2400 - JetDirect Print Server
CategoryPrint Server
LanguageEnglish

Related product manuals