If during program entry you encounter the message
MEMORY
FULL,
then there is not enough room in program memory for the line you
just tried to enter.
You
can make more room available by clearing pro
grams or other data. See "Clearing One or More Programs" below, or
"Managing Calculator Memory* in appendix B.
The
Catalog
of
Programs
(MEM)
The catalog of programs is a list of all program labels with the num
ber of bytes of memory used by each label and the lines associated
with it. Press
fill
mem
I
{PGM}
to display the catalog, and press [r] or
§§(a] to move within the list.
You
can use this catalog to:
•
Review
the labelsin programmemoryand the memorycostof each
labeled program or routine.
• Execute a labeled program. (Press fxlcn or [rTsI while the label is
displayed.)
• Display a labeled program. (Press Hi prgm Iwhile the label is
displayed.)
n Delete specific programs. (Press Hi
clear
Iwhile the label is
displayed.)
• See the checksum associated with a given program segment. (Press
•fSHOWl.)
The catalogshows you how many bytes of memoryeach labeled pro
gram segment uses. The programs are identified by program label:
LBL
C
831.5
Number of
bytes
used
by program C
Clearing
One
or
More
Programs
To
clear
(delete
from
memory)
a
specific
program:
1. Press Bl
mem
I
{PGM}
and display (using[T) and
HH)the
label
of the program.
5:
Simple
Programming
85
To Next Page
Loading...
