46
3. Tap the General tab and enter a network name (SSID).
Note: If a network was detected in step 2, the SSID is
automatically entered and cannot be changed.
4. In the Connects to: box, select where your network connects
to (The Internet or Work).
5. If you want to connect to an ad-hoc connection, tap the This
is a device-to-computer (ad-hoc) connection checkbox.
6. If authentication information is needed, from the Configure
Wireless Network screen, tap the Authentication tab.
Note: To determine whether authentication information is
needed, see your network administrator.
7. Select the type of network authentication to use:
a. To use data encryption, check the Data encryption
(WEP enabled) checkbox.
b. To use Shared Key authentication, check the Network
Authentication (Shared mode) checkbox. Type the
network key in the Network Key: box.
c. If a network key is provided by your network
automatically, check the The Key is provided for
me automatically checkbox.
d. For increased security, check the Enable network
access using IEEE 802.1X checkbox. You should
only check this option if it is supported by your network
environment. Ask your network administrator if you are
unsure.
Note: If you are trying to connect to your corporate network,
contact your network administrator for assistance.
360338-xx1 Onyx How Do I.book Page 46 Wednesday, June 23, 2004 1:34 PM
To Next Page
Loading...
