Macintosh dial-in access for with ARA 2.0. MacTCP supported for IP
connections.
Windows and DOS-based dial-out access through NASI and Int 14 for IPX
networks to remote BBS services. IP dialout supported with Telnet.
UNIX workstation dial-in access with SLIP or PPP for IP networks.
LAN-to-LAN routing for IP and IPX.
For more information about the HP Dial-A-LAN modules, see the
accompanying documentation or you can view the information on HP’s web
page: http://www.hp.com/go/network_city.
HP Router 210 Bundle
The HP J3159A AdvanceStack Router 210 Bundle is an optional module for
your 100VG hub. The router module includes two ports:
An external synchronous WAN port supporting RS-232/V.24/V.28, V.35,
X.21, or RS-422/RS-449/V.36 interfaces at speeds of 9.6 Kbit/s to 2.048
Mbit/s. This port allows HP Point-to-Point, PPP, V.25 bis (dial-up/ISDN),
SMDS, frame relay, and LAPB (X.25) connections to other routers, over
point-to-point or switched circuits
An internal Ethernet/802.3 LAN port, through which the router module
communicates with the hub
The router provides both bridging and routing capabilities and supports the
following routing services:
Internet Protocol (TCP/IP protocol suite)
DECnet Phase IV
Xerox XNS
Novell IPX
AppleTalk Phase 2
Transparent bridging with support for the Spanning Tree Protocol
The router module can be configured and managed in various ways:
Through the hub’s RS-232 Distributed Management port, connected
(locally, or through a modem) to a PC running the HP Stack Manager
software supplied with the router module (HP Stack Manager runs the
router module’s VT-100 terminal interface)
Through any standard SNMP network management software, such as HP
Interconnect Manager in HP-UX
Hub Reference
Hub Reference
4-14
To Next Page
Loading...