HP J9576A Access Security Guide

5-8
TACACS+ Authentication
Configuring TACACS+ on the Switch
CLI Commands Described in this Section
Viewing the Switch’s Current Authentication
Configuration
This command lists the number of login attempts the switch allows in a single
login session, and the primary/secondary access methods configured for each
type of access.
Syntax:
show authentication
This example shows the default authentication configuration.
Figure 5-2. Example Listing of the Switch’s Authentication Configuration
Command Page
show authentication 5-8
show tacacs 5-9
aaa authentication 5-10 through 5-16
console
Telnet
num-attempts <1-10 >
tacacs-server 5-17
host < ip-addr >5-17
key 5-22
timeout < 1-255 > 5-23
Configuration for login and enable access
to the switch through the switch console
port.
Configuration for login and enable access
to the switch through Telnet.

HP J9576A Specifications

General

Brand	HP
Model	J9576A
Category	Switch
Language	English