HP J9576A - Page 276

6-60
RADIUS Authentication, Authorization, and Accounting
Accounting Services
Example. If the switch is configured with RADIUS accounting on the switch
to use start-stop for Exec, System, and Command functions, as shown in figure
6-23, there will be an “Accounting-On” record when the switch boots up and
an “Accounting-Off” record when the switch reboots or reloads. (Assume that
Acct-Session-Id is configured for common.)
Figure 6-23. Example of Accounting Session Operation with “start-stop” Enabled
Acct-Session-Id = "003600000001"
Acct-Status-Type = Accounting-On
NAS-IP-Address = 1.1.1.15
NAS-Identifier = "gsf_dosx_15"
Acct-Delay-Time = 5
Acct-Session-Id = "003600000002"
Acct-Status-Type = Start
Service-Type = NAS-Prompt-User
Acct-Authentic = Local
NAS-IP-Address = 10.1.242.15
NAS-Identifier = "gsf_dosx_15"
Calling-Station-Id = "0.0.0.0"
Acct-Delay-Time = 0
Acct-Session-Id = "003600000002"
Acct-Status-Type = Interim-Update
Service-Type = NAS-Prompt-User
Acct-Authentic = Local
NAS-IP-Address = 10.1.242.15
NAS-Identifier = "gsf_dosx_15"
NAS-Port-Type = Virtual
Calling-Station-Id = "0.0.0.0"
HP-Command-String = "reload"
Acct-Delay-Time = 0
Acct-Session-Id = "003600000001"
Acct-Status-Type = Accounting-Off
NAS-IP-Address = 10.1.242.15
NAS-Identifier = "gsf_dosx_15"
Acct-Delay-Time = 0
Record of Switch Bootup
Record of System Accounting Off
When Switch Reboots
Record of reload Command Issued
Record of User Session Start