HP J9576A - Page 633

13-61
Configuring Port-Based and User-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
Figure 13-15.Example of show port-access authenticator vlan Command
Syntax: show port-access authenticator vlan [port-list]
Displays the following information on the VLANs configured
for use in 802.1X port-access authentication on all switch
ports, or specified ports, that are enabled as 802.1X authen-
ticator:
• Authentication mode used on each port, configured with
the aaa port-access authenticator control command (see page
13-21)
• VLAN ID (if any) to be used for traffic from 802.1X-
authenticated clients
• VLAN ID (if any) to be used for traffic from
unauthenticated clients
802.1X configuration information for ports that are not
enabled as an 802.1X authenticators is not displayed.
HP Switch(config)# show port-access authenticator vlan
Port Access Authenticator VLAN Configuration
Port-access authenticator activated [No] : Yes
Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : No
Access Unauth Auth
Port Control VLAN ID VLAN ID
---- -------- -------- --------
2 Auto 0 0