ENWW TCP/IP Configuration 61
6. Enter the range of IP addresses for this scope (beginning IP
address and ending IP address). Also, enter the subnet mask.
then click Next.
Note If subnetting is used, the subnet mask defines
which portion of an IP address specifies the subnet
and which portion specifies the client device. For
more information, see Appendix A
.
7. If applicable, enter the range of IP addresses within the scope
to be excluded by the server. Then click Next.
8. Set the IP address lease duration for your DHCP clients. Then
click Next.
HP recommends that all printers be assigned reserved IP
addresses. This can be accomplished after you set up the scope
(see step 11
).
9. Select No to configure DHCP options for this scope later. Then
click Next.
To configure DHCP options now, select Yes and click Next.
a. If desired, specify the IP address of the router (or default
gateway) to be used by clients. Then click Next.
b. If desired, specify the Domain Name and DNS (Domain
Name System) servers for clients. Click Next.
c. If desired, specify WINS server names and IP addresses.
Click Next.
d. Select Yes to activate the DHCP options now, and click
Next.
10. You have successfully set up the DHCP scope on this server.
Click Finish to close the wizard.
11. Configure your printer with a reserved IP address within the
DHCP scope:
a. In the DHCP tree, open the folder for your scope and select
Reservations.
b. Click the Action menu and select New Reservation.
c. Enter the appropriate information in each field, including
the reserved IP address for your printer. (Note: the MAC
To Next Page
Loading...
Need help?
General
