ENWW TCP/IP Configuration 62
address for your HP Jetdirect-connected printer is
available on the HP Jetdirect configuration page.)
d. Under “Supported types”, select DHCP only, then click
Add. (Note: Selecting Both or BOOTP only will result in
a configuration through BOOTP due to the sequence in
which HP Jetdirect print servers initiate configuration
protocol requests.)
e. Specify another reserved client, or click Close. The
reserved clients added will be displayed in the
Reservations folder for this scope.
12. Close the DHCP manager utility.
NetWare Systems
NetWare 5.x servers provide DHCP configuration services for
network clients, including the HP Jetdirect print server. To set up
DHCP services on a NetWare server, refer to Novell documentation
and support.
To Discontinue DHCP Configuration
CAUTION Changes to an IP address on your HP Jetdirect
print server may require updates to printer or
system printing configurations for clients or
servers.
If you do not want your HP Jetdirect print server configured
through DHCP, you must reconfigure the print server to use a
different configuration method.
1. If you use the printer control panel to set Manual or BOOTP
configuration, then DHCP will not be used.
2. You can use Telnet to set Manual (status indicates “User
Specified”) or BOOTP configuration, then DHCP will not
be used.
3. You can manually modify the TCP/IP parameters through a
supported Web browser using the Jetdirect embedded Web
server or HP Web Jetadmin.
To Next Page
Loading...
Need help?
General
