HP JG221A - Oam Loopback

undo oam errored-symbol threshold
View
System view
Default level
2: System level
Parameters
threshold-value: Errored symbol event triggering threshold, ranging from 0 to 4,294,967,295.
Description
Use the oam errored-symbol threshold command to set the errored symbol event triggering threshold.
Use the undo oam errored-symbol threshold command to restore the default.
By default, the errored symbol event triggering threshold is 1.
Related commands: oam errored-symbol period, display oam link-event, and display oam
configuration.
Examples
# Set the errored symbol event triggering threshold to 100.
<Sysname> system-view
[Sysname] oam errored-symbol threshold 100
oam loopback
Syntax
oam loopback
undo oam loopback
View
Ethernet port view
Default level
2: System level
Parameters
None
Description
Use the oam loopback command to enable Ethernet OAM remote loopback on the Ethernet port.
Use the undo oam loopback command to disable Ethernet OAM remote loopback on the Ethernet port.
By default, Ethernet OAM remote loopback is disabled on an Ethernet port.
Ethernet OAM remote loopback is available only after the Ethernet OAM connection is established and
can be performed only by the Ethernet OAM entities operating in active Ethernet OAM mode.
Related commands: oam enable, oam enable interface, and oam mode.
Examples
# Configure the active Ethernet OAM mode, enable Ethernet OAM, and enable Ethernet OAM remote
loopback on Ethernet 1/0/1.
15