display smart-link group
Syntax
display smart-link group { group-id | all } [ | { begin | exclude | include } regular-expression ]
View
Any view
Default level
1: Monitor level
Parameters
group-id: Smart link group ID, in the range of 1 to 24.
all: Displays information about all smart link groups.
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see the Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use the display smart-link group command to display information about the specified or all smart link
groups.
Examples
# Display information about smart link group 1.
<Sysname> display smart-link group 1
Smart link group 1 information:
Device ID: 000f-e200-8500
Preemption mode: ROLE
Preemption delay: 1(s)
Control VLAN: 1
Protected VLAN: Reference Instance 0 to 2, 4
Member Role State Flush-count Last-flush-time
--------------------------------------------------------------------
Ethernet1/0/1 MASTER ACTVIE 1 16:37:20 2010/04/21
Ethernet1/0/2 SLAVE STANDBY 2 17:45:20 2010/04/21
Table 10 Output description
Field Description
Smart link group 1 information Information about smart link group 1
Preemption mode
Preemption mode, which can be role for preemption enabled or none for
preemption disabled.
Preemption delay Preemption delay time, in seconds
Control-VLAN Control VLAN ID
30
To Next Page
Loading...
