Setting Up and Using Your PC Workstation
Starting and Stopping Your PC Workstation
5
Initializing Your Software
NOTE Do NOT switch OFF the PC Workstation while the software is being
initialized—this could cause unexpected results.
To initialize your software:
1 Turn on the display first, then the PC Workstation.
When the PC Workstation is switched on, the HP PC Workstation’s logo
is displayed. The PC Workstation performs a Power-On-Self-Test
(POST).
2 The software initialization process starts. It displays the software license
agreement, gives you an opportunity to read Working in Comfort
(ergonomics advice for computer users), then asks questions about the
PC Workstation.
3 While the initialization process is running, you can complete the
Warranty Registration card that came with this manual.
4 When the initialization process has finished, click OK and the
PC Workstation will restart.
Creating an Emergency Repair Disk
During the initialization of your software, it is very important that you
create an Emergency Repair Disk for the operating system, when
prompted. HP recommends that you use new diskettes for this purpose.
For more information on how to create these diskettes, refer to the
documentation that came with your application software or operating
system.
Stopping Your PC Workstation
To stop the PC Workstation, first make sure that you have exited all
applications and then use the shutdown command in the Start menu.
When prompted, press the power button on your PC Workstation’s control
panel.
CAUTION Do not use the power button until prompted to do so as you may lose
any unsaved data from open applications.
Chapter1.fm Page 5 Wednesday, December 8, 1999 5:37 PM
To Next Page
Loading...
Need help?
General