4. On the client computer, run Setup from the printing system software CD-
ROM.
5. Install from the host computer, Install using Typical Network Install.
6. Restart the computer when the installation process has been completed.
7. Go to the printer driver's Properties.
8. Go to the Configure tab.
9. Click Update Now.
WORKAROUND: In any host (Windows NT 4.0, Windows 2000, or
Windows XP) to client (Windows NT 4.0, Windows 2000, or Windows XP)
combination, do not use the Update Now button. The host vends the
configuration of the printer to the client.
• ISSUE (External): After adding memory and/or a hard disk to the printer, the
driver does not report the added memory after you click Update Now.
DESCRIPTION: To recreate the condition, add memory to the printer. On
the Configure tab of the driver properties, click Update Now. Information
is not updated to show the added memory, although the printer's
configuration page shows it.
WORKAROUND: Print a configuration page and note the revised memory
value. Click Start, click Settings, and then click Printers. Right-click the
printer, and then click Properties. Click the Configure tab, and then click
More... . Type the memory value shown into the Total Memory dialog
box under Printer Memory.
Local (IR, parallel, and USB) bidirectional support
• ISSUE (External): Some advanced features of the HP LaserJet printing system
are not supported over a parallel or USB printer connection.
DESCRIPTION: Printing system components that require bidirectional
communication are not supported over parallel or USB printer
connections. The components that are not supported over parallel or USB
include:
• Driver Autoconfiguration
• Update Now
• Printer Status and Alerts
WORKAROUND: None.
HP Restricted 11 HP LaserJet 5100 Known Issues
To Next Page
Loading...
