Manually configure IPv4 TCP/IP parameters from the control panel
In addition to using the embedded Web server, you can also use the control-panel menus to set an IPv4
address, subnet mask, and default gateway.
1.
Press Menu
.
2. Press the down arrow
to highlight CONFIGURE DEVICE, and then press OK.
3. Press the down arrow
to highlight I/O, and then press OK.
4. Press the down arrow
to highlight EMBEDDED JETDIRECT MENU, and then press OK.
5. Press the down arrow
to highlight TCP/IP, and then press OK.
6. Press the down arrow
to highlight IPV4 SETTINGS, and then press OK.
7. Press the down arrow
to highlight MANUAL SETTINGS, and then press OK.
8. Press the down arrow
to highlight IP ADDRESS, and then press OK.
-or-
Press the down arrow
to highlight SUBNET MASK, and then press OK.
-or-
Press the down arrow
to highlight DEFAULT GATEWAY, and then press OK.
9. Use the numeric keypad, or press the up arrow
or the down arrow to increase or decrease the
number for the first byte of the IP address, subnet mask, or default gateway.
10. Press OK to move to the next set of numbers. To move to the previous set of numbers, press the
back arrow
.
11. Repeat steps 9 and 10 until the IP address, subnet mask, or default gateway is complete, and then
press OK to save the setting.
12.
Press Menu
to return to the Ready state.
ENWW Network configuration 65
To Next Page
Loading...