HP Laserjet,Color Laserjet P4014n - Page 78

Manually configure IPv6 TCP/IP parameters from the control panel
In addition to using the embedded Web server, you can also use the control-panel menus to set an IPv6
address.
1.
Press Menu
.
2. Press the down arrow
to highlight CONFIGURE DEVICE, and then press OK.
3. Press the down arrow
to highlight I/O, and then press OK.
4. Press the down arrow
to highlight EMBEDDED JETDIRECT MENU, and then press OK.
5. Press the down arrow
to highlight TCP/IP, and then press OK.
6. Press the down arrow
to highlight IPV6 SETTINGS, and then press OK.
7. Press the down arrow
to highlight ADDRESS, and then press OK.
8. Press the down arrow
to highlight MANUAL SETTINGS, and then press OK.
9. Press the down arrow
to highlight ENABLE, and then press OK.
10. Press the down arrow
to highlight ADDRESS, and then press OK.
11. Use the numeric keypad, or press the up arrow
or the down arrow to enter the address. Press
OK.
NOTE: If you are using the arrow buttons, you must press OK after entering each digit.
12.
Press Menu
to return to the Ready state.
66 Chapter 5 Connectivity ENWW