Disable network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols has the
following benefits:
●
Decreases product-generated network traffic
●
Prevents unauthorized users from printing to the product
●
Provides only pertinent information on the configuration page
●
Allows the product control panel to display protocol-specific error and warning messages
Disable IPX/SPX, AppleTalk, or DLC/LLC
NOTE: Do not disable IPX/SPX in Windows-based systems that print through IPX/SPX.
1.
Press Menu
.
2. Press the down arrow
to highlight CONFIGURE DEVICE, and then press OK.
3. Press the down arrow
to highlight I/O, and then press OK.
4. Press the down arrow
to highlight EMBEDDED JETDIRECT, and then press OK.
5. Press the down arrow
to highlight IPX/SPX, and then press OK.
-or-
Press the down arrow
to highlight APPLETALK, and then press OK.
-or-
Press the down arrow
to highlight DLC/LLC, and then press OK.
6. Press OK to select ENABLE.
7. Press the down arrow
to highlight OFF, and then press OK.
8.
Press Menu
to return to the Ready state.
ENWW Network configuration 67
To Next Page
Loading...