Service-mode functions
NVRAM initialization
An NVRAM initialization will return the following device settings to the factory-set defaults:
●
All menu settings, including the fax header and company name
●
Fax numbers and names that are associated with one-touch keys and speed-dial codes
Additionally, all faxes stored in memory are cleared.
Perform an NVRAM initialization
1. On the product control panel, press Setup.
2. Use the arrows buttons to select Service, and then press OK.
3. Use the arrows buttons to select Restore defaults, and then press OK.
When the NVRAM initialization process has been completed, the device control panel shows the
Ready message.
Super NVRAM initialization
A Super NVRAM initialization will return all of the device settings to the factory-set defaults (generic
product mode).
CAUTION: Performing a Super NVRAM initialization will reset the user set password to the factory
default (0000).
NOTE: When the product is turned on, you will be prompted to select the language and country/region
setting before the product will initialize.
1. Turn off the product.
2. Simultaneously press and hold the Cancel button and the right arrow button (> ), and then turn on
the product.
3. Wait until the message Permanent storage init. appears, and then release the Cancel and left
arrow buttons.
Password reset or bypass
●
To reset a user set password to the factory default (0000), perform a Super NVRAM initialization.
See
Super NVRAM initialization on page 185.
●
To access the product menus without returning the device settings to factory defaults, use the
bypass password (12345678901234567).
ENWW Service-mode functions 185
To Next Page
