HP LaserJet Pro M501 - Load paper to Trays 2 and 3; Introduction

Load paper to Trays 2 and 3
Introduction
The following information describes how to load paper in Tray 2 and the optional 550-sheet Tray 3 (part
number F2A72A). The optional tray holds up to 550 sheets of 75 g/m
2
(20 lb) paper.
NOTE: The procedure to load paper for the 550-sheet Tray 3 is the same as for Tray 2. Only Tray 2 is shown
here.
CAUTION: Do not extend more than one paper tray at a time.
1. Open the tray.
NOTE: Do not open this tray while it is in use.
2. Before loading paper, adjust the paper-width
guides by squeezing the adjustment latches and
sliding the guides to the size of the paper being
used.
3. Adjust the paper-length guide by squeezing the
adjustment latch and sliding the guide to the size
of the paper being used.
NOTE: When the tray is extended, the paper
size indicator changes from "A4" to "14".
B6
11
14
16 Chapter 2 Paper trays ENWW