b. Open a Web browser, and in the address line, type the IP address or host name exactly as it
displays on the printer control panel. Press the Enter key on the computer keyboard. The EWS
opens.
NOTE: If the Web browser displays a message indicating that accessing the Web site might not
be safe, select the option to continue to the Web site. Accessing this Web site will not harm the
computer.
2. Open the System tab.
3. On the Device Information page, the default printer name is in the Device Description field. You can
change this name to uniquely identify this printer.
NOTE: Completing the other fields on this page is optional.
4. Click the Apply button to save the changes.
Manually configure IPv4 TCP/IP parameters from the control panel
Use the control-panel menus to manually set an IPv4 address, subnet mask, and default gateway.
1. On the printer control panel, press the OK button.
2. Open the following menus:
●
Network Setup
●
IPv4 Config Method
●
Manual
3. Use the arrow keys and the OK button to enter the IP address, subnet mask, and default gateway, and
then touch the OK button to save the changes.
Link speed and duplex settings
NOTE: This information applies only to Ethernet networks. It does not apply to wireless networks.
The link speed and communication mode of the print server must match the network hub. For most
situations, leave the printer in automatic mode. Incorrect changes to the link speed and duplex settings
might prevent the printer from communicating with other network devices. To make changes, use the printer
control panel.
NOTE: The printer setting must match the setting for the network device (a network hub, switch, gateway,
router, or computer).
NOTE: Making changes to these settings causes the printer to turn off and then on. Make changes only
when the printer is idle.
1. On the printer control panel, press the OK button.
2. Open the following menus:
ENWW Configure IP network settings 57
To Next Page
Loading...
