HP LASERJET Professional P1100 series - Use HP Direct Print (wireless models only)

d. Select the HP Web Services tab and click the Enable button. The product configures the connection
to the Internet, and then a message appears informing you that an information sheet will be
printed.
e. Click the OK button. An ePrint page prints out. On the ePrint page, look for the e-mail address that
is automatically assigned to the product.
2. To print a document, attach it to an e-mail message, and then send the message to the product's e-mail
address. Go to
www.hpeprintcenter.com for a list of supported document types
3. Optionally, use the HP ePrintCenter Web site to define security settings and to configure default print
settings for all HP ePrint jobs sent to this product:
a. Open a Web browser and go to
www.hpeprintcenter.com.
b. Click Sign In, and enter your HP ePrintCenter credentials or sign up for a new account.
c. Select your product from the list, or click the + Add printer button to add it. To add the product,
you need the product code, which is the segment of the product e-mail address that is before the
@ symbol.
NOTE: This code is valid for only 24 hours from the time you enable HP Web Services. If it
expires, follow the instructions to enable HP Web Services again, and obtain a new code.
d. Click the Setup button. The HP ePrint Settings dialog box appears. Three tabs are available:
●
Allowed Senders. To prevent your product from printing unexpected documents, click the
Allowed Senders tab. Click Allowed Senders Only, and then add the e-mail addresses from
which you want to allow ePrint jobs.
●
Print Options. To set up default settings for all ePrint jobs sent to this product, click the
Print Options tab, and then select the settings that you want to use.
●
Advanced. To change the product’s e-mail address, click the Advanced tab.
Use HP Direct Print (wireless models only)
Use HP Direct Print to print directly to the product from any mobile device (such as a smart phone, net book,
or laptop computer).
NOTE: No setup is necessary, but HP Direct Print must be enabled. Your mobile device must have an HP
print application installed.
The HP LaserJet Professional P1102w model does not support HP Direct Print.
1. To enable HP Direct Print, follow these steps:
a. After the product is connected to the network, print a configuration page and identify the product
IP address.
b. At your computer, open a Web browser and enter the product IP address into the address line. The
HP EWS screen appears.
c. Click the Networking tab.
d. On the Networking page, click Wireless Direct Setup. Select the check box, enter the network
name (SSID) in the Wireless Direct Printing Name (SSID) field, and then click the Apply button.
The IP address of the mobile device appears in the Networking page.
44 Chapter 6 Print tasks ENWW