To Next Page

To Previous Page

- 11 -

DESCRIPTION OF BLOCK DIAGRAM

1. Video Controller Part & Display Data Transmitter Part.(MST9251A)

This part amplifies the level of video signal for the digital conversion and converts from the analog video signal to the

digital video signal using a pixel clock.

The pixel clock for each mode is generated by the PLL.

The range of the pixel clock is from 25MHz to 205MHz.

This part consists of the Scaler, DDR-RAM IC which stores program data, Reset IC.

The Scaler gets the video signal converted analog to digital, interpolates input to 1600 X 1200 resolution signal and

outputs 8-bit R, G, B signal to transmitter.

Especially pre-amp / ADC / Video controller/ Transmitter are merged to one chip 'MST9251A' by M-star.

This part transmit digital signal from the Scaler to the receiver of module.

2. Power Part.

This part consists of the 3.3V, 2.5V and 1.8V regulators to convert power which is provided 5V in Power board.

18V is provided for LCD panel .

Also, 5V is converted 3.3V, 2.5V and 1.8V by regulator. Converted power is provided for IC in the main board.

3. MICOM Part.

This part consists of EEPROM IC which stores control data the Micom.

The Micom distinguishes polarity and frequency of the H/V sync are supplied from signal cable.

The controlled data of each modes is stored in EEPROM.

Other manuals for HP LP2065

Questions and Answers:

Need help?

Do you have a question about the HP LP2065 and is the answer not in the manual?

General

3D	Yes
Pixel pitch	0.255 x 0.255 mm
Response time	8 ms
Display diagonal	20.1 \
Display resolution	1600 x 1200 pixels
Vertical scan range	48 - 85 Hz
Horizontal scan range	30 - 94 kHz
Contrast ratio (dynamic)	-
Contrast ratio (typical)	800:1
Display brightness (typical)	300 cd/m²
USB hub version	2.0
DVI-I ports quantity	2
VGA (D-Sub) ports quantity	0
USB Type-A downstream ports quantity	5
LED indicators	Power
Tilt angle range	-5 - 25 °
Cable lock slot type	Kensington
Panel mounting interface	100 x 100 mm
Power consumption (standby)	2 W
Power consumption (typical)	75 W
Storage temperature (T-T)	10 - 60 °C
Operating temperature (T-T)	10 - 35 °C
Storage relative humidity (H-H)	5 - 85 %
Operating relative humidity (H-H)	20 - 80 %
Certification	TCO'03, TUV-Ergo, UL, VCCI, CE, ISO 13406-2
Country of origin	China
Market positioning	Business

Weight and Dimensions