HP M210 802.11n Access Point Quickstart 6 Specifications
D. Test the wireless network
For the purpose of this example, the network to which you connect the M210 must have a
DHCP server and an Internet connection. Furthermore, the Network name (SSID) is
assumed to be the default HP, and the Security method is WPA2 (AES).
1. Disconnect your computer from the PoE switch or injector or the M210.
2. Power off the M210.
• If using a power supply, disconnect it from the M210.
• If using a PoE switch or injector, remove power and disconnect the Ethernet cable
from the M210.
3. Connect the switch or the data in port of the injector to the network.
4. Reconnect and power on the M210.
• If using a power supply, connect the M210 to the network and reconnect the M210
power supply.
• If using a PoE switch or injector, reconnect the M210 to the PoE switch or the data
and power out port of the injector and then power on the switch or injector.
5. Wait until the M210
Power LED stops blinking.
6. Enable the Wi-Fi wireless network interface of your computer or mobile device and
verify that it is set to obtain an IP address automatically.
7. Connect your computer or mobile device to the new wireless network named HP,
providing the WPA2 key you defined earlier when prompted.
8. Confirm that you can browse the Internet through the M210.
E. Perform additional configuration
The M210 management tool is now available wirelessly or wired at: https://<IP address>. For
additional configuration information, see the online help and the M210 Configuration and
Administration Guide.
HP websites
www.hp.com/networking/support
www.hp.com/networking
www.hp.com/support/manuals
www.hp.com
Specifications
Specification Description
Product model number RSVLC-1103
Frequency range 2412–2262 MHz, 5180–5240 MHz, 5745–5825 MHz
Actual operating frequencies depend on regulatory approval for the country of
use.
Dimensions 19.35(w)x12.7(d)x3.81(h) cm, 7.62(w)x5(d)x1.5(h) inch
Weight 0.34 kg (0.75 lb)
Voltage 100–240 VAC
Current 0.44 A
Maximum power rating 5.28 W
Antenna Internal 2.4/5 GHz MIMO omni-directional (2)
Operating temperature 0°C to 40°C
Non-operating/storage
temperature
-40°C to 70°C
Operating/non-operating
relative humidity
5% to 95% @40°C, noncondensing/
5% to 95% @65°C, noncondensing
Altitude Up to 4600 m (15,000 ft)
To Previous Page
Loading...
Need help?
General
