Configuration page
Print a configuration page
NOTE: This section applies to the HP LaserJet Pro 200 color M276nw MFP model only.
1. From the Home screen on the product control panel, touch the Setup button.
2. Touch the Reports button.
3. Touch Configuration Report.
Print-quality troubleshooting tools
Repetitive image defects
If the product output has a consistent, repetitive defect, use the table in this section to determine which
part needs to be replaced based on the measured distance between the repetitions of the defect.
NOTE: The following table replaces the graphical repetitive defect ruler. You can make your own
ruler by using these measurements. For the most accurate results, use a metric ruler.
Table 2-3 Repetitive image defects
Distance between
identical defects
Component Notes
22.3 mm (0.87 in) Developer roller (one rotation) Appears in a single color plane.
26.7 mm (1.05 in) Charge roller (one rotation) Appears in a single color plane.
28.5 mm (1.12 in) RS roller (one rotation) Appears in a single color plane.
44.0 mm (1.73 in) Registration roller
56.5 mm (2.22 in) Fuser film (one rotation) Appears in all color planes.
59.7 mm (2.35 in) Fuser pressure roller (one
rotation)
Appears in all color planes.
56.5 mm (2.22 in) Transfer roller Appears in all color planes.
69.0 mm (2.71 in) Cartridge-to-cartridge spacing Distance between each color image drum
75.8 mm (2.98 in) Image drum (one rotation) Appears in a single color plane.
633.6 mm (24.94 in) ITB Because the ITB is longer than a page, you might have to
look at multiple pages to determine if a repetitive defect is
present.
46 Chapter 2 Solve problems ENWW
To Next Page
Loading...
