NOTE: Making changes to these settings causes the printer to turn off and then on. Make changes only
when the printer is idle.
1. From the Home screen on the printer control panel, swipe until the Setup menu displays. Touch the
Setup
icon to open the menu.
2. Open the following menus:
●
Network Setup
●
Link Speed
3. Select one of the following options:
●
Automatic: The print server automatically configures itself for the highest link speed and
communication mode allowed on the network.
●
10T Full: 10 megabytes per second (Mbps), full-duplex operation
●
10T Half: 10 Mbps, half-duplex operation
●
100TX Full: 100 Mbps, full-duplex operation
●
100TX Half: 100 Mbps, half-duplex operation
●
1000T Full: 1000 Mbps, full-duplex operation
4. Touch the Save button, or press the OK button. The printer turns off and then on.
ENWW Configure IP network settings 89
To Next Page
Loading...