8. When you reinstall the assembly, register the glass against the top and left edge rubber cushions
(callout 6). Reinstall and tighten the upper left clip and screw (callout 7). Reinstall the sliding glass
clip tight against the glass and tighten the screw (callout 8). Reinstall and tighten the lower left and
bottom clips and screws (callout 9).
CAUTION To avoid print quality problems, make sure that you do not leave fingerprints
on the underside of the glass assembly.
9
7
8
6
Figure 5-95 Remove the scanner glass assembly and top cover (7 of 7)
ENWW Scanner 239
To Next Page
Loading...