14 HP Media Center PC Getting Started Guide
6 Set the switch to match your display
resolution. Move 2 (1080i), or 3 (720p), or
4 (480p/576p) to the On position (C). Or
leave all of the switches in the Off position for
480i/576i only resolution.
7 Connect the S-video, composite, or
component video cables to the analog video
cable and then to the back of the PC.
8 Connect the power and turn on the PC.
9 If the resolution is not correct, turn off the PC
and disconnect the power.
10 Move the correct switch to the On position on
the analog video cable to match the new
resolution.
11 Connect the power, and then turn on the PC.
C
To Next Page
Loading...
Need help?
General