System Configuration Menu
Select To do this
Language Support Change the Setup Utility language.
Processor C4 State Enable/disable the processor C4 standby state.
Boot Options Set the following boot options:
●
f10 and f12 Delay (sec.)―Set the delay for the f10 and
f12 functions of Setup Utility in intervals of 5 seconds
each (0, 5, 10, 15, 20).
●
HP QuickWeb―Enable/disable the QuickWeb Boot
menu in Setup Utility.
●
Internal Network Adapter boot―Enable/disable boot
from Internal Network Adapter.
●
Boot Device Priority―Set the boot device priority for:
◦
Internal hard drive (select models only)
◦
USB Floppy
◦
USB CD/DVD ROM Drive
◦
USB flash drive
◦
USB Hard drive
◦
USB Card Reader
◦
Network adapter
NOTE: Only the devices attached to the system
will appear in the boot order menu.
Diagnostics Menu
Select To do this
Hard Disk Self Test (select models only) Run a comprehensive self-test on the hard drive.
Memory Test Run a diagnostic test on the system memory.
78 Chapter 5 Setup Utility
To Next Page
Loading...
Need help?
General
