Remove the display assembly:
1. Disconnect the following cables and grounding tape from the system board and cable routing
clips:
(1) Display panel cable
(2) Display panel cable grounding tape
(3) WLAN cables
(4) WWAN cables (select models only)
(5) Microphone cable
CAUTION: Support the display assembly when removing the following screws. Failure to
support the display assembly can result in damage to the display assembly and other device
components.
2. Remove the 2 Phillips PM2.5×5.0 screws (1) that secure the display assembly to the device.
3. Remove the display assembly (2).
Component replacement procedures 67
To Next Page
Loading...
