Changing a DriveLock password
To access the DriveLock settings in Computer Setup, follow these steps:
1. Open Computer Setup by turning on or restarting the computer, and then pressing esc while the
“Press the ESC key for Startup Menu” message is displayed in the lower-left corner of the screen.
2. Press f10 to enter BIOS Setup.
3. Use the arrow keys to select Security > DriveLock passwords, and then press enter.
4. Use the arrow keys to select the location of the internal hard drive, and then press f10.
5. Use the arrow keys to select the field for the password you want to change. Type your current
password in the Old password field, and then type the new password in the New password field
and in the Verify new password field. Then press f10.
6. To save your preferences, use the arrow keys to select File > Save changes and exit. Then follow
the instructions on the screen.
Your preferences go into effect when the computer restarts.
58 Chapter 5 Security
To Next Page
Loading...
